-:- Sun Shine -:-

Products / Categories

Sunshine Enclosures are designed on the basis of current applicable standards

The most important user aspects are embodied in this enclosure system concept. So our products are distinguished by their safety.

All sheet steel enclosures are manufactured from electro galvanized sheet steel and aluminum enclosures from high-grade aluminum alloys having high impact strength.

Sunshine Enclosures being placed in various environments that demand resistance against corrosion, scratching and ageing a high quality painting process is required.

The Sunshine Enclosures are therefore painted with protective Polyester type oven dried paint.

The electrostatic powder painting process gives a tough surface and a good build up on corners and edges. Good adhesion ensures that the paint does not crack or split when the material is drilled or punched. The paint has very good chemical characteristics and is resistant to sunlight.

PAINTING PROCESS

Degreasing, Phosphate and Rinsing:
During this process the steel is cleaned and passivity, this way the product will not corrode and good adhesion of the paint to the steel surface is achieved.

DRYING

To make sure that the products are completely dry before the painting process start, they are dried at 100 degrees.

POWDER COATING

The powder coating is electrostaticaly applied. This way all faces are covered inside and outside during high mechanical strength, very good corrosion protection and resistance to chemical temperature and weather variations

QUALITY WITHOUT BOUNDARIES

Quality management is a continuous process involving - planning development as well as production from the drawing board up to the release into the market.

Our products are tested and made sure that the market demands and standards are met. Testing can involve corrosion resistance level of protection or customer special requirements.